Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Introduction
PCIe TO Gigabit ETH Board (C) for Raspberry Pi 5, supports Raspberry Pi OS, is driver-free, side-mounting, and comes with an acrylic mounting plate.
Features
1.PCIe TO Gigabit ETH Board (C) Designed for Raspberry Pi 5
Supports Raspberry Pi OS, Driver-Free, Plug And Play
2.Connecting To PI5 Via 16PIN Cable
Based On 16PIN PCIe Interface Of Raspberry Pi 5
3.High-Performance Controller
Onboard Original High-Performance RTL8111H Chip
Supports Raspberry Pi OS, Driver-Free, Plug And Play
4.Comes With Transparent Acrylic
Mounting Plate
Adopts Side-Mounting Solution To Save Space Above The Raspberry Pi 5
5.Supports Power Supply Via PCIe Cable
Specifications
CONTROLLER---RTL8111H
ETHERNET PORT---RJ45 Gigabit Ethernet
PICE INTERFACE---PICe x1 GEN2
POWER SUPPLY---5V
NETWORK STANDARD---10/100/1000Mbps
INDICATOR STATUS---accessing 1000M network: the green indicator keeps blinkingaccessing 100M network: the yellow indicator keeps blinking
Note
PCIE interface is not enabled on the Raspberry Pi by default.
Development Resources
https://www.waveshare.com/wiki/PCIe_TO_Gigabit_ETH_Board_(C)?Amazon
Package Content
PCIe TO Gigabit ETH Board (C) x1
Transparent acrylic mounting plate x1
PH2.0 3PIN cable ~5cm x1
PCIe-Cable-50mm x1
Standoff pack x1
