AC Infinity AIRPLATE T7, leises Kühllüftersystem 12' (30 cm) mit Thermostatsteuerung, für Heimkino-AV-Schränke

1a Produkt mach was es soll . Unbedingt beachten das es kein Euro Stecker ist Adapter muss man selber besorgen . Wäre gut wenn das in der Beschreibung dabei stehen würde Produkt kommt nämlich aus USA.

These are incredibly high quality fans and these are almost completely silent. They have a finish that makes you feel like the cabinet came with them. It holds the tempuratures perfectly and as long as you are strategic with them (I've found thats really easy to do in most cases) they work really well, the screen is nice and readable and doesn't light up the room at night (also has a screen-off mode) amd the power draw on them is negligible. The packaging is simple and makes these feel even more premium and they come with templates for easy installation. As seen in my photos they do work on metal cabinets too (though it's difficult to cut and make it look good but I think it turned out nice.)I highly recommend watching some videos on installation to avoid screwing it up and making it look bad. They keep my servers cool to a point where the fans don't run as hard and that saves money there too. I actually use these on my entertainment center to cool my ps5 that's enclosed in there too and it's perfect!This is the high quality brand you're looking for!My ONLY complaint, is the alarm feature is kinda confusing and I'm not sure if the alarm even works at the same time as the fan curve... (edit: it does work. You have to set it in alarm mode then switch it to the desired mode you want)

Fantastische oplossing, zeer mooi afgeleverd. Goed product. Is stil maar niet onhoorbaar natuurlijk anders 5 sterren!

Ein tolles Produkt, bin restlos begeistert.Es macht was es soll und funktioniert tadellos. Kann ich nur weiter empfehlen.

Works as expected, installed in the bottom of my AV storage cabinet. Simple to install and is decently quiet.

Habe die Airplate T7 als einfaches Entlüftungssystem für das Gehäuse meines 3d Druckers bestellt. Funktioniert genau so wie es soll und hält die Innentemperatur konstant auf dem eingestellten Wert.

Sehr gute Qualität von der Verpackung bis hin zu den Geräten.Bis jetzt laufen die Lüfter ausfallfrei und funktionell. Negativ: leicht erhöhter Geräuschpegel bei Lüfterlauf

Impeccable

Habe die Elemente dieses Systems für die Temperatur geregelte Kühlung meines Heim-EDV-Racks verwendet. Funktioniert sehr gut. Die Komponenten sind recht hochwertig.

Sehr leise Dank der Lüftersteuerung.Kann ich wirklich empfehlen.Aber ist wirklich kaum zu hören.Habe es in einem Netzwerkschrank eingebaut.

I bought this fan to cool the air around my valve hi-fi amplifier. Even though it sits on an open shelf, heat was clearly building up, especially on the shelf above where another device sits. I built a simple wooden frame for the fans so that I could suspend them from the shelf above and drag the hot air from the valves out to the side of the equipment. At the back would be better, if you can. It wasn't practical in my case. Normally these fans would be mounted in a more solid cabinet. I just used 1 piece of 26mm by 17mm by 600mm cut for 2 sides and 2 widths to make a clamp over the shelf. Wood-stained the frame and used 4 metal angle brackets and some screws.The thermostat controller has a wired temperature sensor that can be placed wherever you want to test. I attached it to the shelf above with Blu-tak (the hi-fi owners friend) so it reads the temperature right above the valves. The controller is powered by the supplied transformer plug. This is a US product but I got in the UK with a UK 3-pin plug. The controller has a number of modes, including setting the fans to 3 different speeds all of the time, or what they call smart mode. This is what I use. I selected 35 degrees Celsius as the temperature I want it to try not go over. If the temperature gets to that, it will run the fans at full tilt. 2 degrees below that and the fans go to mid-power to keep the noise down, and 3 degrees below the fans spin up to low speed. Below that and the fans stop, which means there's no noise and no wasted power. The controller displays in Celsius or Fahrenheit, by the way.There is also a spare USB socket to run another single or pair of fans, which you can buy separately, and they will all be controlled from the one controller unit. I currently run a USB desk fan from this in order to push the air away on the other side. I also screwed the controller to a couple of short bits of wood (same as the frame, above) to make a stand, where again it might be built into a cabinet.In the cooler months the fans can keep the temperature at 35 degrees, but with a summer ambient temperature in the room of 28 degrees C it tops out nearer 40 degrees C. The controller does have an alarm if the temperature gets too high, I think it flashes the backlight of the display. I've not seen that happen. Normally the controller displays the actual temperature of the sensor and the threshold that has been set, in smart mode. There are only a couple of buttons on the front of the controller that you need to use to set up your preferred mode and temperature, after that it's hands-off.I'm very pleased with this unit. The finish and build quality appear good, and it should last me 30 years. It's an expandable system and the fans run pretty quietly.

The fans arrived on time. I unpacked the unit and was pleasantly surprised. Good manual, supplied bolts, and I love the tracing templates that came with it! One template for the fans, and one for the thermostat. I wanted a push pull system so I flipped one of the fans around. The case is solid and well built but easy to take apart and put back together. Took me about 10 mins at my own pace. Setting the fan up was simple and after I cut the holes for the fans and thermostat I had it up and running in 5 mins. My small cabinet has both a PS3, and 4 in it currently. I only use one at a time but with the cabinet closed it easy reaches 98F-102F in no time. I have the fan set for 80. It keeps my consoles nice at around 76. It is not loud even at full blast and pull/pushes enough air for what I need it to do. The great thing about these fans are they can daisy chain together if you require more. For my application this fan set-up was perfect. I have no complaints about this unit for the application I purchased it for.

👍