Ihr Warenkorb ist leer
Ihr Warenkorb ist leerDie beliebten Keller-Vorlagen erfordern die Verwendung von Bits mit Schaft-Pilotlagern. Dieser Bit ist speziell für den Einsatz im Keller-System konzipiert. #45882, Durchmesser (D) 7/16, Winkel (A°) 7°, Schnitthöhe (B) 3/4, Schaft (D) 1/4, Gesamtlänge (L) 2-5/8, Typ Schwalbenschwanz, Ersatzlager 47712, Keller Nummer 16. 33/15 33, Rillen, 2, Keller Schwalbenschwanz, 7 Grad x 7/16 Durchmesser x 3/4 x 1/4 Zoll Schaft mit oberem Bb
Richard
Bewertet in den USA am2. Mai 2023
This bit claims to be a replacement for the Keller/whiteside dovetail bit used with the 1500/1601 dovetail jigs. While it does work, the bit I received is so narrow that I had to recalibrate the pin template of my Keller jig to the extreme end - about 3/16 back - from the Keller scribe line to get the pins to fit with these tails. Aesthetically these look fine but I’m surprised about how much smaller they are.
John Florida
Bewertet in den USA am2. Mai 2022
Worked as well as the original Keller bit.
Pat Davias
Bewertet in den USA am9. März 2021
I have a dovetail jig with 1/2 inch fingers. I didn't see that the bearing was 9/16s and would not fit in the jig fingers. The replacement bearing that was 7/16 OD was $25 from Nampa. I ended up removing the bearing and using the bit with the 7/16 template sleeve on my router. I would give the bit five stars as it makes great looking dovetails but wouldn't work on my jig out of the box.
Customer
Bewertet in den USA am26. Juli 2020
The dovetail angle of this bit does not fit the Keller jig. You have to pare every tail to fit the dovetails this bit cuts. I measured the top of an original bit with this one and the original one was wider at the top creating a different angle to the tail cuts.... bummer, back to Keller to buy a new bit!
T. Ulidhdjfkdnmvlvkvmghjgnhfhgrggddfnhbff
Bewertet in den USA am2. Oktober 2018
I always buy the Amana bits to use on my Keller dovetail jig since it makes very clean cuts
Produktempfehlungen
92.63€
43 .99 € 43.99€