Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktinformation
- Für CNC oder Holzbearbeitung Reihenbohrmaschine
- Vorschubgeschwindigkeit: 2~8（M/min)
- Umdrehungsgeschwindigkeit: 4500~6000(R/min)
- Maximale Bohrtiefe: 20mm für Bohrer mit 57,5mm Länge und 33mm Bohrer mit 70mm Länge
- Legierungsklinge – professionelles Klingendesign, hohe Festigkeit und reibungsloses Bohren
- Lackierprozess – glatte und schöne Oberfläche
Verarbeitungsbereich: Spanplatten, Mehrschichtplatten, Melaminplatten, Lackplatten, Bambus, Massivholz, etc.
Timo
Bewertet in Deutschland am 6. Januar 2024
Der Dübelbohrer läuft in Linksrichtung sehr sauber. Er fräst präzise und sauber. Ebenso transportiert er das Holz gut ab. Bleibt lange scharf. Kann ich empfehlen.
RichWdWk
Bewertet in den USA am6. November 2024
Die Medien konnten nicht geladen werden.
Barreras Family
Bewertet in den USA am24. Oktober 2024
Perfecto
michael reimann
Bewertet in Deutschland am 19. November 2024
Er macht was er soll...Löcher bohren!
James Misora
Bewertet in den USA am13. August 2024
Just what I was looking for.
buddha-dog
Bewertet in den USA am1. April 2024
Very nicely made. The business end is solid brazed-on carbide, so the full cutting edge and first 6 mm or so of the drill is all carbide. The grind is clean and accurate, with spurs for a chip-free entry point if you exercise a little care at the start of the hole. The body of the drill appears to be HSS but could be tool steel, doesn't matter at all I expect because it's plenty stiff and nicely coated to encourage smooth chip evacuation.The cutter diameter is perhaps .01 mm under, so 4.99, which suits me fine. No drill is going to produce an undersized hole and .01 mm is .0004" (four tenths), so extremely accurate and plenty, plenty good enough for boring wood products.This is the size of drill used for so-called "euro" screws used to hold on European-style cup hinges. It's also the standard size for shelf pins and most other standard accessories in euro-style frameless cabinetry (IKEA style).A carbide bit is really a must for this work because the manufactured wood products (particle-board, MDF, plywood) used for these cabinets is abrasive and will just eat up normal HSS or tool-steel bits. This one will last for many, many holes and is well worth the few dollars investment.This bit is made for dedicated machines that make these holes where frameless cabinets are manufactured, but with a little care will work fine in a drill chuck in a drill press or even a cordless drill. Just make sure the flat on the shank is aligned between two of the jaws otherwise the drill won't run true/concentric.Definitely a thumbs up, would do it again and recommend.
Catherine
Bewertet in den USA am12. April 2024
This Boring Bit cuts clean and stays sharp so far I am very happy with the performance.
Produktempfehlungen