Ihr Warenkorb ist leer
Ihr Warenkorb ist leerCMT ORANGE TOOLS 03.51.0106 - FRÄSER UND BOHRER ABLAGEBRETT
Geppetto Digitale
Bewertet in Italien am 16. März 2024
Il prodotto lo conoscevo gia e ho preso un secondo organizzatore ma rispetto all'immagine non è fornito di adattatore per le frese , ne da 8 ne da 12mm
Kunde
Bewertet in Deutschland am 6. November 2021
Ich wollte meine 8mm-Fräser sortieren. 8mm-Einsätze gibt es aber garnicht. Nur zöllig und 10mm.
tired of jUNK
Bewertet in den USA am29. Juni 2018
Works well with the CMT bushings.
Joseph L. Stephens
Bewertet in den USA am1. August 2018
I really like this bit organizer. The only fault I've found is the bushings are to tight. There is a very simple solution to this problem. Insert the bushings of your choice and drill them out 1/64 inch bigger than the router bit shank. Drill slow with a sharp drill bit. The router bits than fit snug and makes for easy inserting and removal and finger safety. If you are going to be turning the organizer upside down than this may not be for you,
Eric Pecquerie
Bewertet in Frankreich am 17. August 2017
Moyennement satisfait. Pas de support pour les fraises. Il faut acheter, pour une somme très importante, des manchons pour se loger dans les alvéoles et tenir les fraises. Absolument pas expliqué sur la fiche Amazon. Et, de plus, le diamètre des alvéoles est n'importe quoi. On ne peut pas fabriquer simplement des supportAchat à éviter de mon point de vue.
fugu58
Bewertet in den USA am24. Februar 2012
Good product, very sturdy; however, stating "bushings not included" is an understatement. It appeared to me, from the picture, that these were manufactured to hold 1/2" bits by default, therefore I did not need bushings. I was wrong. You need bushings for ALL size bits. One I realized this, I found 20 packs for $4 somewhere else and everything was fine.
Produktempfehlungen
