Ihr Warenkorb ist leer
Ihr Warenkorb ist leerSie müssen keine Regel mehr ausrichten oder mit Setup-Blöcken durcheinander bringen, wenn Sie versuchen, die Höhe des Frässtifts oder des Tischsägeblattes genau einzustellen. Die 3,8 x 10,2 cm große Basis verfügt über einen Magnetstreifen, um das Messgerät in Position zu halten, während die große digitale Anzeige Sie Ihre Fräserhöhe genau auf die Tiefe einstellen können, die Sie benötigen. Schnelle, genaue und wiederholbare Höheneinstellung ermöglicht es Ihnen, präzise Schnitte zu machen und Ihre Einstellungen zu wiederholen. Die Form des Ambosses ermöglicht es Ihnen, das Messgerät zu verwenden, um die Position des Fräszauns auf bis zu 11,4 cm einzustellen. Zeigt sowohl Brüche als auch das Dezimaläquivalent gleichzeitig an, damit Sie wissen, dass Ihr Bruch genau eingeschaltet ist, nicht wie bei anderen Bruchauslesevorgängen aufgerundet oder heruntergerundet. Genauigkeit auf +/- 0,01 Zoll, 1/500 Zoll oder 0,025 mm
Peter
Bewertet in Kanada am 7. Mai 2021
Things I like:- It's relatively cheap.- It works.- Strong magnet in the base holds it to metal surfaces.Things I don't like:- Metric resolution in only +/-0.05mm even though Imperial units read +/-0.001inches (which is +/-0.025mm). This is likely a rounding limitation in the digital controller that's used.- It doesn't arrive perfectly square (see pic).- The digital readout is at 90 degrees, so you get a sore neck and this might lead to the occasional human error when you're looking at the display.- It doesn't have a carbide tip on the end of the scribe. The scribing tip is also not replaceable. But then If you're using this so much that you're wearing out the scribe you should probably be buying higher quality tools.- The base is aluminum and looks pretty flat, but it's not going to be as flat as a ground steel base.
Richard Dessureault
Bewertet in Kanada am 17. Mai 2021
Works well . As usual, you get what you pay for!
Brahm Chehadi
Bewertet in Kanada am 28. November 2018
Great little peice to have if you work with precise measurements
Drastic
Bewertet in den USA am3. März 2017
I've used a smaller, all-plastic Wixey digital height gauge for a year, and it has proven to be very useful. The one under review here is more stoutly built, and has a heavy metal base that will prevent it from falling over, and it can extend up to 4 1/2 inches (longer than the plastic model). This one is a bit more versatile, just as accurate, just as easy to use. I use it to measure table saw height, router bit height, router bit distance from the fence, distance from the drill press fence to the drill bit. Highly recommended for your woodworking shop.
Kerry Pierce
Bewertet in den USA am12. November 2009
I purchased this tool after buying and using the . Both units appear to use the same measuring and display device and are well designed and made for their particular applications. The display is relatively large with numbers that are fairly easy to read in most circumstances. I wish that they had a backlit display for better viewing, but they are pretty good the way they are. The required battery is included and installation is fairly easy and straightforward.Both units are as accurate as anything else that I tested them against and both have smooth, easy operation. It's very nice that they display the fractional units when they are appropriate. I think they're a pretty good value and are going to be well used in my shop.
Produktempfehlungen
