Ihr Warenkorb ist leer
Ihr Warenkorb ist leerUnsere CV-Gelenkmanschetten bieten verschiedene Methoden, um das Entfernen des CV-Gelenks während der Installation zu beseitigen. Uni-Fit-Stiefel können über das CV-Gelenk gespannt werden, Quick Boots kommen in Hälften, die durch eine selbstklebende Schweißverbindung verbunden sind, und Speedi Boots sind geteilte Stiefel, die um die Achse verschraubt sind.
Customer
Bewertet in den USA am22. Mai 2025
The split boot repair works as it should as long as you take your time and follow the directions. I would assemble the boot and glue before packing the CV joint with grease. On our 2003 chrysler town & country we had plenty of room to assemble the 2 piece boot with the glue and then pack the cv joint with grease. We completed our repair under 30 minutes.
thomas
Bewertet in den USA am20. Januar 2025
I have used a fair amount of these over the years on my 4x4 truck because sometimes you don't have the time to disassemble the whole 4wd hub assembly to get the axle out to do it right.The old ones used to be a decent rubber compound with screws that held the two sides together and while it didn't last long, it lasted long enough.This new style is more of a semi-flexible plastic, like a cheap dollar store toy, and you glue the two halves together, problem is...the glue doesn't hold anything but your fingers together! I am very mechanically inclined and do a lot of work on my own cars, that being said, this is one frustrating contraption to install.I ended up using a different glue I had on hand and will see how that goes. The supplied glue is far too thin to work as it should. I cleaned the surface and applied a nice bead of glue, held it together for longer than the recommended time...it still didn't hold.I honestly don't have much hope for this thing doing much good but I can follow up later. My main goal is to keep dirt and moisture out of the joint until I can install the OEM boot in the spring.
Customer
Bewertet in Kanada am 12. Mai 2024
Easy, but had to trim shaft side (too small of a hole) and cv joint side ( too large to fit over joint)
Jim R
Bewertet in Kanada am 11. Juni 2024
Clamps not strong enough to keep boot on axle !
Francisco Cantu
Bewertet in Mexiko am 8. August 2023
Excelente factor precio-desempeño, cumple cabalmente con el objetivo para el que fue diseñado.
Produktempfehlungen
