Warenkorb

Ihr Warenkorb ist leer

Ihr Warenkorb ist leer

Geekstory BE-880Q GPS Module with Flash QMC5883L Compass GPS Antenna TTL Level 38400bps for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller

Kostenloser Versand ab 25.99€

32.99€

14 .99 14.99€

Auf Lager

1.Farbe:/


Info zu diesem Artikel

  • Dieses BE-880Q GPS-Modul verwendet den neuesten Chip der 10. Generation. BE-880 GPS-Modul ist Dual-Modul-Kompass, mit elektronischem Kompass IC QMC5883L
  • BE 880Q GPS-Modul hat Flash, um die Konfiguration zu speichern. So müssen Sie das nächste Mal nicht zurücksetzen, wenn Sie es verwenden
  • Wenn Sie es für Raspberry Pi verwenden, wird kein Treiber benötigt. Hier ist die Verbindung mit RPi, Rot auf 3,3 V, Schwarz zu GND, Grün zu TXD Weiß zu RXD. Das blaue (TX) Licht blinkt beim Einschalten und zeigt an, dass Datenausgang vorhanden ist
  • DIts data Level is TTL or RS-232, Default TTL level. Um einen RS232-Ausgang zu erhalten, müssen Sie ein TTL-zu-RS232-Konverterkabel verwenden
  • Baudrate: 4800bps bis 921600bps, Standard 38400bps Sie können die benötigte Baudrate in diesem Bereich nach Ihren Bedürfnissen einstellen


Produktmerkmale:
Chip: M10050
Kompass:QMC5883L
Frequenz: GPS L1 C/A,QZSS L1 C/A/S,BDS B1I/B1C,Galileo E1B/C,SBAS L1 C/A:WAAS,EGNOS,MSAS,GAGAN
Betriebsmodus: GPS + BDS + Galileo + SBAS + QZSS
Empfindlichkeit: Track -166dBm, Re-arrest -160dBm, Cold Start -148dBm, Hot Start -160dBm
Horizontale Genauigkeit: 1,5 m CEP 2D RMS SBAS Hilfsmittel (für offenen Himmel).
Geschwindigkeitsgenauigkeit: 0,05 m/s.
Dynamische Kurswinkel-Genauigkeit: 0,3 Grad.
1PPS Zeitgenauigkeit: RMS 30ns, 99% 60ns
Startzeit: Kaltstart 27s, Hotstart 1s, Assisted Start 1s
Baudrate: 4800bps - 921600bps, Standard 38400bps
Ausgangspegel: TTL-Pegel
Ausgangsprotokoll: NMEA, UBX
NMEA-Sätze: RMC, VTG, GGA, GSA, GSV, GLL
Aktualisierungsfrequenz: 0,25 Hz - 18 Hz, Standard 1 Hz.
Zweiter Impuls: konfigurierbar von 0,25 Hz bis 10 MHz, Standardzeitraum 1 s, hoher Pegel hält für 100 ms
Graviationsbeschleunigung: Spannung: DC 3,6 V - 5,5 V, typisch 5,0 V.
Stromstärke: normal 50 mA/5,0 V.
Maße: 28 x 28 x 8,4 mm.
Anschluss: 1,25 mm, 6-polig.
Im Lieferumfang enthalten:
1 x BE-880Q GPS-Modul
3 x Kabel


Bob
Bewertet in den USA am6. Mai 2024
The unit works great, even indoors about 10 feet from a window. At least it did until I applied 12 volts to VCC by mistake and let out the magic smoke. I ordered another immediately .
Vitaliy Shtykhno
Bewertet in Deutschland am 5. März 2024
Not super best to catch the signal, recommend to replace it for 880 chip
Alberto Ardit
Bewertet in Italien am 27. Mai 2024
Utilizzato su drone FPV. Non è velocissimo ad agganciare i satelliti, ma una volta fatto il 3D fix, in volo poi arriva a vederne anche 26/28. Configurato tramite adattatore a 115.000bps e 10kHz.Consigliato.
Jörg Krüger
Bewertet in Deutschland am 19. Juli 2024
Dss erste Modul war defekt also zurück geschickt. Das zweite bekam ich natürlich nicht mehr zum Preis von 19.99 sondern 25.00 Euro. ( Ein Schelm der böses dabei denkt.)
Thomas J. Coyle III
Bewertet in den USA am18. Februar 2024
As the headline says, the GPS worked great, but the compass had issues. At boot up of my Flight Controller the GPS always worked fine, even indoors, but the compass was kind of hit or miss. Sometime it would work and sometimes it wouldn't. It calibrated just fine, but during normal operating conditions sometimes it would be stuck at one particular compass angle and other times it would respond normally. Needless to say, the compass caused numerous preflight arming errors.
Martin
Bewertet in Deutschland am 15. September 2024
It dosnt have built in battery, as shown in pictures.
Paul Nagelkerke
Bewertet in Kanada am 22. April 2024
Fast Delivery
urup
Bewertet in Spanien am 23. Dezember 2023
Buen producto
Produktempfehlungen

92.90€

43 .99 43.99€

4.8
Option wählen