Ihr Warenkorb ist leer
Ihr Warenkorb ist leerHD-Schalter, verbesserte Kugelgelenk-Enden mit 360 Grad Crimp-Methode und 4130 Stahl. Dies ist eine wirklich verbesserte Version.
Chris
Bewertet in den USA am25. September 2024
These tie rod ends Fit JD455 tie rod with matching threads. LH thread on one and RH thread on the other.
CParks
Bewertet in den USA am15. Mai 2024
Bought and installed these on a JD X720 after one tie rod end dropped off while mowing. Had no issues with the threads or installing them. Took some fairly accurate measurements before taking the old ends off and put them together with the same measurements taken earlier and all has been well. Probably have 30-40 hours on them. If anything goes wrong earlier than I think it should I'll chime back in.
Rick
Bewertet in den USA am13. Mai 2024
Worked very well to replace the OEM part. Installed with no issues, used the mower for 5+ hours after installing the part.
Dean Bucur
Bewertet in den USA am12. September 2024
A little more expensive than some tie rod ends on Amazon, but worth the extra money.
Rancher
Bewertet in den USA am22. Mai 2020
Fast delivery. Perfect fit on my John Deere X485. 10 min install. I used 3/4” and 5/8 wrenches. I suggest you coat the bolt threads with anti seize as the old ones were pretty corroded.Impact wrench made it an easy install.You will need a vise to remove old ends and back off set nut.Use a sharpie to mark the top off tie rod. Back off set nut 1/4 turn. Install new ends and tighten down set nut so your alignment is good. May need to adjust.
Produktempfehlungen
10.60€
5 .99 € 5.99€
26.46€
11 .99 € 11.99€