Ihr Warenkorb ist leer
Ihr Warenkorb ist leerSchrittwinkel ist 1,8°+-0,09°, 2 Phasen, bis zu 110 mN.m hohes Haltemoment, 1,0 A Nennstrom, DC 2,5 V Nennspannung, auch kompatibel mit 12 V und 24 V Spannung
Edgar
Bewertet in den USA am6. Februar 2023
Motor failed in less than a few months conveniently outside the return window.
VinnniE
Bewertet in Kanada am 21. März 2023
*TLDR = review + updated review, works fine while it worked, fit is good, doesn’t get hot on the same settings.After 15 4-5 hours print, I can safely say this stepper works fine. Fitted right in the clockwork 2 printed piece, without changing any settings in config, it doesn’t get hot more than the chamber temp.Cheers****Well I was wrong! Couple weeks after my original review it did went out! Disassemble it to see that the copper wires of one of the coil set was cut/burnt.Yeah so, if you don’t use it daily like I do, it might last, but as for me, I will steer clear of this one.Cheers
Produktempfehlungen
50.00€
23 .99 € 23.99€
25.00€
11 .99 € 11.99€