Ihr Warenkorb ist leer
Ihr Warenkorb ist leerDies ist notwendig, um das angegebene Kaliber aufzuladen. Inklusive Shell Holder und Suppentopf. Kunststoffbox zur Aufbewahrung 3 Stück Kalkfüller 223 Lesen Genauigkeit.
Janice or Jim Drury
Bewertet in Kanada am 7. September 2024
Fit and finish is great. %100 satisfied.
Kunde
Bewertet in Deutschland am 30. April 2024
Gut und preziese Munition Herstellung möglich
Pietro Romano
Bewertet in Italien am 13. Mai 2023
Ottimi in qualità e prezzo nella media
Javier Mena
Bewertet in Mexiko am 25. Januar 2020
El producto está muy bien constituido buen material
Bethany
Bewertet in Großbritannien am 17. Mai 2020
*WARNING* Does not fit the lee pro 1000 powder dispenser unfortunately.
Rib-I
Bewertet in den USA am11. Juli 2014
I exclusively use Lee dies because I have had good luck with them and they are priced right. This is a great set because it restores brass cases to factory form so cases fired from any gun can be reloaded and will work perfect (opposed to the other less set that only resets the neck).I've been loading hornady cannelured 22 (.224) 55gr bullets and have extremely good luck. I find that when I trim my brass to recommended length (1.760") and I seat the bullet right at the cannelure that the OAL ends up being about 2.220" which performs excellent in my Colt Le6920.For set up, follow the instructions and you should have no problems. Since the factory crimp die is separate I started out by using the bullet seating die and progressively tightening it until the cannelure sate just right in the case. You can continue to tighten it to further seat the bullet to your liking before switching to the factory crimp die (bullets with cannelure is not required but I recommend it since it provides easy guidance for bullet depth). I use a light crimp and have been having good luck.Now for a couple of pointers. I bought the lee universal decapping die to remove all primers to protect my sizing die. I've had several pins break and figure its better to break the universal die pin than the sizing die pin. So basically I have these three dies and the universal decapping die in the turret press at all times and just crank away. However, lately I switched out the decapping die and dropped the universal powder through die in the rotation and like it better so I can leverage four pulls and yield a functional round. If you have a five hole turret then this is a non-issue. I still weigh each load individually (not sure I trust a powder thrower at this point) but the powder through die speeds things up significantly.Lastly, these are standard dies so they will fit in any press. Use lube... I spray Hornady One Shot (can is about $10) on approximately 50-75 rounds in a small shoe box and then shake them around in there to get lube all over.
Produktempfehlungen
10.95€
4 .99 € 4.99€
21.99€
10 .99 € 10.99€