Ihr Warenkorb ist leer
Ihr Warenkorb ist leerProduktinformation
Details der Anschlussdose
Reservierte Löcher
Mit reservierten Löchern wird die wasserdichte Leistung optimiert, wenn Sie nur die Löcher bohren müssen, die Sie benötigen.
Eingebauter Montagebolzen
Alle Gehäusegrößen sind mit Bolzen für die Montage von Leiterplatten und DIN-Schienen-Komponenten ausgestattet.
Gummi-Tülle
Abnehmbare Abdeckung mit Gummidurchführung. Es kann die gesamte elektrische Box für eine bessere wasserdichte Leistung zu versiegeln.
Packliste
Montesano
Bewertet in den USA am30. Januar 2025
Works perfect!
Wolfgang Müller
Bewertet in Deutschland am 22. Februar 2025
Leider sind die Aussparungen für die Stutzen nicht genügend ausgearbeitet, so dass leider bei einer Dose das Gehäuse beschädigt wurde.Ansonsten ist die Dose top.
Jedibear
Bewertet in Kanada am 7. November 2024
as advertised
Ramin
Bewertet in Kanada am 6. November 2024
Proper for installation
Mario Desbiens
Bewertet in Kanada am 16. November 2024
Merci
William Taber
Bewertet in den USA am15. August 2022
Size of box reviewed: 5.9 x 5.9 x 2.8 (150mm x 150mm x 70mm).I found the material of the box allowed for easy modifications with needed holes to be drilled. The lid fits nicely on the box, with a built-in seal around the edge to keep it weatherproof. Overall, I was very pleased with the quality of workmanship and material of this project box.My project required several holes to be drilled in my box. The pre-scored 1" (25 mm) knock-outs are nice, but I needed a 1-1/8" (28 mm) hole where two of those knock-outs were located. So, I drilled a small pilot hole in the center of the knock-outs and then used a hole-saw attachment on my drill to bore the required 1-1/8" (28mm) hole (see pic with yellow hole saw). My project was to supply and distribute multiple voltages to be used by different devices. I mounted 2 ScanStrut weatherproof USB-A ports (ASIN B071WXWS9C) on the sides of the box. Inside the box, I also mounted a 6 VDC buck converter (ASIN B07SGJSLDL) and a 12 VDC buck/boost converter (ASIN B07N3QT628). From each of these converters, I will route the outputs through the cable glands mounted on the top of the box. The LeMotech box comes with 2 black cable glands, but I used 2 grey ones (ASIN B094ZDSD86) instead of the ones that came with the box. These required 2 custom 12 mm holes to be drilled in the top side of the box..This has turned out to be one of the smoothest project box jobs I have done. Hints for good results: drill holes slowly into the material, and do NOT force the drill/saw into the material. When sawing, proceed slowly so as to CUT the material, rather than BURN it. Since this project, I have ordered another one of the boxes of this same size, as well as another in a smaller size, for use in other projects.
Produktempfehlungen
36.20€
16 .99 € 16.99€