Ihr Warenkorb ist leer
Ihr Warenkorb ist leerSargento de cabezal 25x38mm
Angel
Bewertet in Spanien am 8. März 2025
Compré estos sargentos porque quería fabricar con unos perfiles metálicos unos sargentos de grandes dimensiones.Compré los perfiles metálicos, hice los taladros para colocar las cabezas en los extremos y entre cabeza y cabeza hice multitaladro para poder tener varias posiciones y así abarcar muchas dimensiones.Las cabezas de sargentos son de buena calidad, como nos acostumbra la marca.Muy contento con ellos
Client d'
Überprüft in Belgien am 19. November 2023
Idéal pour le bricoleur amateur, simple et robuste.
Scott J. Taylor
Bewertet in den USA am9. Juni 2022
I have an old set of Record clamp heads and these are equal in quality. Very nice stuff. They did arrive missing a nut and the package was open...
Massimo padovani
Bewertet in Italien am 12. Dezember 2022
Ottimo prodotto che ti dà la possibilità di creati una morsa da banco o morsetto da legno della lunghezza che vuoi e come vuoiSi può utilizzare con unica staffa di legno eseguendo tutta una serie di fori per avere più posizione a seconda delle esigenze o tagliare più staffe con i fori dedicati e sostituirle a seconda delle esigenze, non conoscevo questo prodotto ma ora che l'ho scoperto sicuramente ne comprerò un altro.Consigliatissimo e più economico dei morsetti a tubo, poi ovviamente dipende sempre dall'utilizzo che se ne fa.Comunque sia solido e molto versatile.
Christian
Bewertet in Deutschland am 18. Dezember 2020
habe zwischenzeitlich mehrere Bretter geklebt aus rel. schmalen Leisten. Bisher alles einwandfrei, kann gut Druck ausüben. Durch die ebene Auflage der Bretter ist auch die Ebenheit gut. Ich verwende 3 Stück dieser Klemmen.Mit 3 Stück denke ich kann man ca. 60 cm abdecken; wenn es breiter wird, entweder dazwischen mit normalen Zwingen zusätzlich spannen oder weitere dieser Klemmen kaufen.Ich habe keine Dachlatten o.ä. verwendet, weil ich denke, die würden sich zu stark verbiegen. Stattdessen Streifen aus Siebdruckplatte (auch Multiplex wäre sicherlich gut), etwa 70 mm hoch. Die Kante, die mit dem zu veklebenden Holz in Berührung kommt, mit einem Klebeband (Paketband) abgedeckt, damit das dort nicht haftet.Man sollte ausreichend Bohrungen vorsehen; bisher habe ich im Abstand von 10 cm Bohrungen für die Klemmen, werde aber verkürzen auf 5 cm; wenn die Zwingen zu weit ausfahren, bekommt das die Tendenz zum Abheben (versteht man was ich meine...?)
Harry Herbert 301
Bewertet in Großbritannien am 18. November 2012
The advantage of this type of clamp they are very flexible in what you can repair provided that you can find a long enough piece of hardwood that will fit between the two ends of the clamp.Where does one find such a piece of hardwood at no cost! Luckily our very old cat had badly scratched a leather settee/sofa: the sofa had to be replaced . I did not want to pay for a skip ,so I took it apart and saved the ash hardwood bars inside for use with this clamp. I drilled these wooden bars every couple of inches and then I gave them a light coat of tung oil for damp/rot protection. I have used these clamps in combination with these long pieces of timber for a wide variety of "Clamp and Glue" repair jobs.I also have an earlier "Record" generation (not Irwin Record) of these clamps (not bought on this site ) made by the original Record company (taken over later to become Irwin Record as per now) . These Record originals have a smaller amount of screwing thread and a more restricted clamping capacity as a result.The newer clamps (the ones I am reviewing here) have about twice as much clamping thread which is very useful as the clamping capacity is thereby increased a lot by this extra thread. So in this respect the newer ones are better.However the old ones had a fixing rod attacked to a short link chain (so these rods could never be lost). The new variety has a nut and bolt as a fixer which could be lost or mislaid easily.The old Record clamps are stamped "No 130" whereas the newer ones (bought here) are stamped "M130" .I don't know which I like the best the best : they can be used together which I do. I think in "real terms" the clamps are a lot cheaper than they use to be.Their old price meant that I treated them as almost a luxury purchase: now they are quite affordable and represent very good value for a well made and durable product that will last a long time if kept properly greased and protected from rust.I find these tools very well made and useful. I tend to use them more than "Steel Bar " type clamps which have a steel bar rather than this wooden bar to connect the ends.
Produktempfehlungen
