Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Es hat einen großen Schrottentladungsraum, wenig Widerstand und ist während der Schrottentladung reibungslos.
Die Verwendung hochwertiger Materialien macht die Schneide etwas schärfer, reduziert die Schnittkraft und bricht den Bohrer, verbessert die Qualität der Lochwand.
Higgy
Bewertet in Großbritannien am 5. Mai 2021
Purchased these for detail work in my modelling room. Very handy for small holes, obviously and for removing small areas for detailing on my model submarine. Used in a high speed dremmel drill as a rotary file as well as a drill. Not broken one yet so very pleased with purchase.
Ken
Bewertet in Kanada am 24. Februar 2019
Was quite satisfied with the service and quality of the product which I used building a model of the Mayflower
Shan A. Greer
Bewertet in den USA am3. Juli 2017
These work great for plastic models. The larger shank works well with a pin drive. The sizes of this and similar models are pretty accurate. Recommended.
Nicolò
Bewertet in Italien am 11. September 2017
per allargare l'ugello dell'estrusore da 0.4 a 0.7 se ne sono rotte 2. mai successo in tanti anni di onorata carriera
L. Davis
Bewertet in den USA am22. November 2016
Has worked just fine making pcb. Fine for IC pins too small for discreat componets but have worked fine. Saw 1 review where person said they had troubles in a drill press breaking. These are for a cnc turning 20,000 rpm and not in a drill press at much lower speeds. Would recommend.
Produktempfehlungen