Ihr Warenkorb ist leer
Ihr Warenkorb ist leerGerader Spannzangenhalter, CNC-Fräsdrehmaschine ER11 Spannzange. Ein gutes Ersatzteil für Ihre alte Schraube.
Pilot40D
Bewertet in Großbritannien am 21. Dezember 2024
For the money it is pretty straight. Only using it in a pillar drill for small bit sizes but works very well.
Jon Kraus
Bewertet in den USA am14. Oktober 2024
Used for tensile testing Instron by drilling a hole through the side.
Mouse Guy
Bewertet in den USA am6. Februar 2021
Hollow all the way through and runs true. Using this to adapt ER11 collets to my upgraded ER20 spindle so I cut it down a bit. Also handy as an extension when you need to reach deep into a cavity with a small bit but don't want to lose too much rigidity.
Steven
Bewertet in Kanada am 2. Juni 2019
Nut was not fully machined out so it would only put pressure on one side of the collet
jkello1
Bewertet in den USA am19. April 2017
I use this to prepare metallurgical samples for DSC analysis. This is, without a doubt, the secret weapon that I've been looking for for years. I can prepare ultra thin samples with a mass of just 25mg with ease! One modification that I made was to dip the shaft in rubber so that I can have a more sturdy grip.I realize that this is not what this tool is meant for, but it is an excellent application!
Produktempfehlungen
