Ihr Warenkorb ist leer
Ihr Warenkorb ist leer Product Description
This current detection sensor mainly detects and prevents equipment from overcurrent by setting the overcurrent point, so as not to cause equipment damage.
Specification:
Type: Current Detection Sensor
Current detection range: AC 0.3A-5A
Operating voltage: DC 5V / 12V / 24V(optional)
Working current: less than 10mA
Relay load: AC 250V 10A Max , DC 30V 10A Max.
The overcurrent signal setting is adjustable and the resolution is set to 0.3A.
Induction sensitivity: Potentiometer is adjustable.
Operating frequency range: 20Hz-400Hz
Output mode: switch signal output
Maximum detection wire diameter: 5.2mm
Mounting hole: hole diameter is 3mm, hole pitch is 52.5mm
Operating environment: -40℃ - 85℃
Board size: Approx.38 * 44mm / 1.5 * 1.7in
Board Description:
VCC: Operating voltage positive;
GND :Operating voltage negative;
NO: Normally open, the relay pulls before the NO and COM disconnect, short-circuit after the suction;
COM: common, relay common interface;
NC: Normally closed, the relay before the NC and COM short-circuit, after pull off;
Package includes:
2 x Current Detection Sensor(12)
1 x Screwdriver
jack893
Bewertet in Japan am 4. März 2024
電流検知したりしなかったり安定しません返品しました
Produktempfehlungen
