Ihr Warenkorb ist leer
Ihr Warenkorb ist leerDiese Original-Vintage-Pilzgriffe verfügen über das gleiche ergonomische gerippte Design wie sie sie vor 25 Jahren verkauft haben. Das faltbare Rippenmuster bietet außergewöhnlichen Komfort und hilft, die Ermüdung der Arme zu reduzieren. Produktmerkmale: Ergonomisches Profil, große, faltbare Rippen für verbesserten Komfort, geschlossenes Ende mit Pilz-Logo, paarweise verkauft.
Customer
Bewertet in den USA am15. April 2024
One fits snug, stays on the handlebars but the other is too big and just slides off the handlebars
motopsyco
Bewertet in den USA am29. August 2022
These are not bicycle grips. Note the listing says MX grips not BMX grips. That out of the way this is the second set of ODI Mushroom grips that I have purchased for motorcycles. First set went on a Suzuki DR350 and felt so good that when It was time to replace the handlebars on my Royal Enfield 650 I used them again. They work great to reduce engine vibration from being felt through the handlebars without being oversized and feeling like big cruiser grips.
Bryan
Bewertet in Australien am 6. Januar 2021
One grip is bigger than the other do spins on handlebars
mercury 135
Bewertet in den USA am28. Februar 2016
They were too short to fit my cruiser which is what I bought them for. However, they will fit my dirt bike, so am saving them for when those wear out, since I didn't keep my receipt. The quality looks ok. I have no complaints other than I thought they were for cruisers, but were too short.
Blake McDonald
Bewertet in den USA am17. März 2016
I really like these grips a lot, I've been using them on two of my bikes for a while now. They are good quality and do a nice job absorbing vibrations. I like the larger than normal and cushy grip, they are comfortable riding all day.I use these on my 2009 Yamaha WR250X daily commuter, they fit perfect in every way. I cut off the end caps with a razor blade so I can use my hand guards. I much prefer them over the Pro Taper Pillow Top Grips I had previously.I also use these on my 1986 Yamaha SRX600. I also cut the ends off so I can use the clip-on bar end weights. They fit no problem.As some have said they are different sizes but this is because the small one goes directly on the 7/8 inch handlebar and the big one goes over the throttle tube. Use a little soap and they slide right on. I actually ordered two for my SRX600 thinking this would be a problem due to the reviews however it worked out and I liked them so much I put the other set on my WR250X.
Produktempfehlungen
